“Single-point ground” – it depends... For bonding to work, it has to be... For the ham station, use... EVERYTHING! A single, solid ground system made of short, heavy, direct connections can satisfy all
Customer Service
Wire Gauge: The wire connecting your equipment to the ground rods should be thick enough to handle potential surges. A minimum of 6 AWG copper wire is recommended for high
Customer Service
Placing an 8′ ground rod into the ground directly below the antenna is recommended for a base station. Then, run a #8 solid copper ground wire from the U-Clamp, attaching the antenna to the mast.
Customer Service
EVERYTHING IN THE STATION IS AN ANTENNA! A single, solid ground system made of short, heavy, direct connections can satisfy all of the requirements for... Block, R. R., The “Grounds” for Lightning
Customer Service
A heavy copper wire (#6 AWG) or larger would be used to interconnect the mast to this ground rod. Clamps made for this purpose would be used to secure the wire at both ends.
Customer Service
Provide a ground rod near a corner within 6” of the corner in each maintenance hole and handhole. Bond to the ribbon in the maintenance hole.
Customer Service
One wire of the feedline connects to the base of the antenna, and the other connects to ground. The connection to ground has to have a low RF resistance, or you''ll expend too much of your power
Customer Service
A ground plane is for RF performance, a ground is required for static and lightning protection. DO NOT confuse the two. If you do not ground your antenna and mast properly, your
Customer Service
Whether you''re installing a mobile CB in your vehicle or setting up a base station, proper grounding and RF bonding can mean the difference between crystal-clear communication and
Customer Service
A heavy copper wire (#6 AWG) or larger would be used to interconnect the mast to this ground rod. Clamps made for this purpose would be used to secure the wire at both ends.
Customer Service
Lightning travels miles through the air to get to ground and your antenna and tower are just a convenient path for it. Current will follow your coax (either the shield or the center conductor or
Customer ServicePDF version includes complete article with source references. Suitable for printing and offline reading.
